Filter
Top Products
• In any case of other than City, you have to register the
latitude and longitude at first. (See Mark Loc Section)
1. Select “Home”, for example, using the ▲ or ▼ button.
2. Press the SELECT/TRAP button. After “Selected” indication,
the display returns to the Normal mode.
Note: To deselect the destination, choose “OFF” then press
the SELECT/TRAP button. Choosing “OFF” will
eliminate the direction arrow showing the way to your
destination.
2. Mark Loc (Mark Location)
To enter into this
mode, select “Mark
Loc” using the ▲ or
▼ button, and press
the SELECT/TRAP
button. At this mode,
you can register the
latitude and longitude
data for 7 specific
points as shown in fig.
Select the point you
want to register using
the ▲ or ▼ button,
and press the
SELECT/TRAP button.
After “Marked”
indication, the display
returns to the Normal
mode.
Note: If the Status Indicator is red, you will not be able to
program your location. Move to a different location in
order to receive better satellite reception.
When you approach the location, the detector sounds alert tones
in 3 levels as follows.
17
Distance Alert Alert
(Radius/Mile) Tone Time Display Time
Level 1 1.0 3 sec 3 sec
Level 2 0.5 3 sec 3 sec
Level 3 0.1 3 sec 3 sec
GREEN
GREEN
GREEN
[ ]SW
[ ]SW
GREEN
[ ]SW
[ ]SW
GREEN
[ ]SW
[ ]SW
GREEN
[ ]SW
[ ]SW
GREEN
[ ]SW
[ ]SW
GREEN
[ ]SW
[ ]SW
[ ]SW [ ]SW
[SELECT/TRAP]SW
[SELECT/TRAP]SW
"Menu Mode"
[EXIT/ALERT]SW
[ ]SW[ ]SW
US076Z (GPSRD) OM 9/4/01 13:39 Page 17