Filter
Top Products
AgGPS 332 GPS Receiver User Guide 43
Getting Started 4
41.3 Beacon DGPS mode
When in Beacon DGPS mode, the Home screen displays “B” (Beacon
DGPS) in the lower left corner. Figure 4.10 explains the status
indicators that appear on the first line of the Home screen display when
the receiver is in this mode.
Figure 4.10 Beacon DGPS status
Table 4.4 describes messages that can appear when the receiver is in
Beacon DGPS mode.
Table 4.4 Beacon DGPS operating mode messages
Message Description
B The receiver is operating in Beacon mode.
Beacon Searching The receiver is searching for beacon signals.
Beacon Tracking The receiver is tracking beacon signals and is attempting
to gain lock.
Beacon Idle Beacon DGPS is not active.
Beacon FFT The receiver is looking for a beacon across the signal
spectrum.
Beacon Disabled Beacon DGPS is disabled in the receiver. You will need to
change configuration settings to enable Beacon DGPS.
External RTCM Differential corrections are being provided by an external
source, through port A or port B.
B H – R 310.0 ÷ ø15
The beacon signal-to-noise
ratio. S/N values range from
0 to 30. High numbers are
best. Above 6 is acceptable.
The beacon frequency. Frequency varies
depending on the beacon used.
Indicates the receiver is using Beacon DGPS.
The beacon operating mode.