TomTom V2 Automobile User Manual


 
109
6. Once the system is bled properly and free from foaming,
there should not be any appreciable change in the oil
level in the reservoir, when the engine is started or stopped
repeatedly.
7. Now the car is ready to be driven.
Final oil level should be upto 'Max' mark of reservoir.
Do not allow fluid level to drop significantly or run out
of the reservoir during the above operation. This may
induce air into the system.
Severe damage could occur to the power steering
pump due to dry running (Running without sufficient
oil and due to severe cavitation on account of air
entry due to low oil level). This could lead to loss of
power assistance, damage and failure of the power
steering system.
Do not start the engine without oil in the power
steering system. This will result in serious damage
to the pump. In case of an emergency, disconnect
the pump drive belt and then start the engine or drive
slowly as vacuum assistance for brake would not be
available.
Always use recommended oil from sealed
containers. Any contaminated oil poured in the
system will result in damage to the pump and gear
box.
Avoid mixing of different brands of oils.
MAINTENANCE & CAR CARE Power Steering & Battery
BATTERY :
Check the battery for proper electrolyte level and corrosion
on the terminals.
During normal operation, the battery generates gas
which is explosive in nature, a spark or open flame
can cause the battery to explode causing very
serious injuries.
Keep all sparks & open flames and smoking
materials away from the battery.
Getting electrolyte in your eyes or on the skin can
cause severe burns. Wear protective clothing and
a face shield or have a skilled technician to do the
battery maintenance.
The battery contains sulphuric acid (electrolyte)
which is poisonous and highly corrosive in nature.
1. Check the battery for electrolyte level against the marking
on the battery outer case.
2. Check the battery terminals for corrosion (a white or
yellowish powder). To remove it, cover the terminals with
a solution of baking soda. It will bubble up and turn brown.
When this stops wash it off with plain water. Dry off the
battery with a cloth or paper towel.
Coat the terminal with petroleum jelly to prevent future
corrosion.