Filter
Top Products
105
9. Tighten bleed screw and remove tube.
10. Replace dust cap on bleed screw.
11. Repeat same procedure on rear right, front right and then rear
left.
12. If bleeding continues without success it means air is being
drawn in past the bleed screw threads.
13. Close bleed screw at the end of each downward stroke of pedal.
14. Allow pedal to return fully and slowly.
15. Tighten bleed screw finally after last downward stroke of pedal.
16. Replace the dust cap on the bleed screw.
17. Apply brake pedal hard and check for any leaks.
Brake and clutch pedal adjustment :
1. Ensure that clutch pedal height is the same as the brake pedal
height.
2. Connect the front end of the clutch cable to the clutch release
lever and adjust the cable by setting the nut by hand so as to
get clutch pedal height same as brake pedal height, and cable
is tight.
3. Due to wear of the clutch disc, the pedal lever will lift up. Readjust
the pedal height again, using clutch cable.
NOTE : Brake pedal height adjustment is required only in case
of component removal, etc. Adjustment is not required during
normal maintenance.
Clutch Adjustment NutClutch Adjustment Nut
Clutch Adjustment NutClutch Adjustment Nut
Clutch Adjustment Nut
1
23
4
FRONT
REAR
MAINTENANCE & CAR CARE Clutch & Brakes