Filter
Top Products
106
Brake Light Switch
4. Adjust brake light switch, gap of 3 mm to be maintained as
shown in the fig. after loosening the lock nut on the switch.
Tighten the nut after adjustment. This should be done with brake
pedal in complete released condition.
Do not apply tightening force over the switch body/terminal
block as it may damage the switch. Electrical supply for
brake lights is 'ON' without ignition switch. Under normal
condition the switch shall be 'OFF' and the lights are not
glowing.
Any improper adjustment may result in either brake grabbing
unneccessarily or spongy brakes.
MAINTENANCE & CAR CARE Clutch & Brakes
Lock Nut
3 mm