Filter
Top Products
PI-9
PRE-DELIVERY INSPECTION
Pre-delivery Inspection
25.WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-6, Wheel
Alignment.> and <Ref. to RS-10, Wheel Align-
ment.>
26.TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
malfunction indicator light starts blinking. If the light
blinks, return the ignition key to LOCK and discon-
nect the test mode connector. Then, turn the igni-
tion key to ON again. If the malfunction indicator
light blinks at that time in spite of the disconnected
test mode connector, carry out an engine diagno-
sis.
• With OBD MODEL
• Without OBD MODEL
27.IMMOBILIZER SYSTEM
1) Check that the engine starts with all keys that
are equipped on vehicle.
2) 60 seconds after turning the ignition switch from
ON to ACC or OFF, or immediately after removing
the key, check that the security indicator light blink-
ing.
NOTE:
If malfunctions occur, refer to “IMMOBILIZER (DI-
AGNOSIS)”.
28.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any ab-
normal noises are observed, immediately stop the
engine and check and repair the necessary compo-
nents.
29.EXHAUST SYSTEM
Listen to the exhaust noise to see if no abnormal
noises are observed.
30.INDICATOR LIGHT
Check that all the indicator lights are off.
31.CLOCK
Check the clock for normal operations and enough
accuracy.
32.AUDIO
Check if the radio for functions fully, speaker emitts
sound normally and noise level is normal. Also
check the CD, MD unit operations.
33.FRONT ACCESSORY POWER SUPPLY
SOCKET
Check the front accessory power supply socket op-
erations.
34.LIGHTING SYSTEM
• Check the headlight operations.
• Check the stop light operations.
• Check the other lights for normal operations.
35.WINDOW WASHER
Check that the window washer system injects
washer fluid to the specified area of windshield
shown in the figure.
Front injection position:
A: 350 mm (13.78 in)
B: 162 mm (5.91 in)
C: 300 mm (11.81 in)
D: 500 mm (23.62 in)
(A) Test mode connector (Green)
(A) Read memory connector (Black)
(B) Test mode connector (Green)
PI-00119
( A )
PI-00120
( A )
( B )
PI-00121
A
B
CD
B
A