Filter
Top Products
PI-3
PRE-DELIVERY INSPECTION
Pre-delivery Inspection
CHECKS WITH ENGINE RUNNING
DYNAMIC TEST WITH VEHICLE RUNNING
CHECKS AFTER DYNAMIC TEST
17. AT front differential oil Check that the AT front differential oil level is normal.
18. Engine coolant Check that the engine coolant level is normal.
19. Clutch fluid Check that the clutch fluid level is normal.
20. Window washer fluid Check that the window washer fluid level is normal.
21. Front hood latch check Check that the hood is closed and latched securely.
22. Keyless entry system Check that the keyless entry system operates normally.
23. Seat (1) Check the seat surfaces for stain or dirt.
(2) Check the seat installation conditions and functionality.
24. Seat belt Check the seat belt installation conditions and functionality.
25. Wheel alignment Check that the wheel alignments are properly adjusted.
PROCEDURE Check point
26. Test mode connector Test mode connectors
27. Immobilizer system (1) Check that the engine starts with all keys that are equipped on vehicle.
(2) 60 seconds after turning ignition switch from ON to ACC or OFF, or imme-
diately after removing key, check that the security indicator light blinking.
28. Starting condition Start the engine and check that the engine starts smoothly.
29. Exhaust system Check that the exhaust noise is normal and no leaks are found.
30. Indicator and warning lights Check that all the indicator and warning lights are gone out.
31. Clock Check that the clock operates normally.
32. Audio Check the radio, CD and MD player for normal operation.
33. Front accessory power supply socket Check that the front accessory power socket operates normally.
34. Lighting system Check that the lighting system operates normally.
35. Window washer Check that the window washer system operates normally.
36. Wiper Check that the wiper system operates normally.
37. Power window operation check Check the power window for normal operations.
38. Sunroof Check that the sunroof operates normally.
39. Door mirror Check that the remote control mirror operates normally.
PROCEDURE Check point
40. Brake test Check the foot brake for normal operations.
41. Parking brake Check the parking brake for normal operations.
42. AT shift control Check that the AT shift patterns are correct.
43. Heater & ventilation Check that the heater & ventilation system operates normally.
44. Air conditioner Check that the air conditioner operates normally.
45. Cruise control Check that the cruise control system operates normally.
PROCEDURE Check point
46. ATF level Check that the ATF level is correct.
47. Power steering fluid level Check that the power steering fluid level is normal.
48. Fluid leak check Check for fluid/oil leaks.
49. Water leak test Spray the vehicle with water and check for water leaks.
50. Appearance check 2 (1) Remove the protective coating (if any).
(2) Check the body paints for damage and stain.
(3) Check the plated parts for damage and rust.
PROCEDURE Check point