Filter
Top Products
75
MAINTENANCE AND LUBRICATION
Periodic Maintenance Schedule (Cont.)
" More often under severe use, such as dirty or wet conditions
NOTE: Inspection may reveal the need for replacement parts. Always
use genuine Polaris parts available from your Polaris dealer.
Item Hours or
Odometer
Frequency Remarks
J Brake pad wear 10 hrs/100
miles
Monthly Inspect periodic ally
" Engine breather filter 20 hrs Monthly Inspect--replace annually and as need-
ed
Battery 20 hrs Monthly Check Terminals/cl ean/check fluid level
" Transmission Oil Level 25 hrs Monthly Inspect monthly; change annually
" General Lubrication 50 hrs 3 months Lubricate all fitti ngs, pivots, cables , etc.
J Throttle Cable/ETC Switch 50 hrs 6 months Inspect--adjust, lubricate, replace if nec-
essary; pre-ride inspection item
Choke (Enricher)Cable 50 hrs 6 months Inspect--adjust, lubricate, replace if nec-
essary
CarburetorFloat Bowl 50 hrs 6 months Drain bowl periodic ally and prior
to storage
" Engine Oil - Level/Change 100 hrs/1000
miles
6 months Check Level Daily; Break in Service at
1 month. Changeoil more often in cold
weather use
Oil Filter 100 hrs/1000
miles
6 months Replace with oil change
Coolant strength/pressure test
system
100 hrs 6months Inspect strength seasonally; pressure
testsystem annually
Engine breather hose 100 hrs 6months Inspect
" Rear Suspension 50 hrs 6 months Inspect, tighten fasteners
" Drive Chains 50 hrs 6 months Inspect daily, adjust and lubricate if
needed
J Drive Belt 50 hrs 6 months Inspect--adjust, replace if necessary
" Front hubs/fluid check 50 hrs 6 months Check monthly
Shiftlinkage 50 hrs 6 months Inspect, lubricate, adjust
J Steering 50 hrs 6 months Inspect daily, lubricate
" Rear Axle/Center Axle 50 hrs 6 months Inspect bearings
" Front Suspension 50 hrs 6 months Inspect--lubricate, tighten fasteners
CAUTION
Due to the nature of the adjustments marked with a J,itis
recommended that service be per formed by a n authorized Polaris
dealer.