Filter
Top Products
Symptom Cause Action (See)
Switching the viewing angle is
not possible.
The DVD playing does not feature
scenes shot from multiple angles.
You cannot switch between multiple angles if
the DVD does not feature scenes recorded
from multiple angles.
You are trying to switch to multiple
angle viewing of a scene that is not
recorded from multiple angles.
Switch between multiple angles when watch-
ing scenes recorded from multiple angles.
The picture is extremely unclear/
distorted and dark during play-
back.
The disc features a signal to prohibit
copying. (Some discs may have
this.)
Since this unit is compatible with the copy
guard analog copy protect system, when play-
ing a disc that has a signal prohibiting copy-
ing, the picture may suffer from horizontal
stripes or other imperfections when viewed
on some displays. This does not mean this
unit is malfunctioning.
Problems during Video CD playback
Symptom Cause Action (See)
The PBC (playback control)
menu display cannot be called
up.
The Video CD playing does not fea-
ture PBC.
This operation is not possible with Video CDs
not featuring PBC.
PBC is turned off. Turn PBC on. (Page 40, Page 44)
Repeat play and track/time
search are not possible.
PBC is turned on. Turn PBC off. (Page 40, Page 44)
Error messages
When problems occur with disc playback, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest PIONEER Service Center.
Message Cause Action (See)
ERROR-02 Dirty disc Clean disc.
Scratched disc Replace disc.
ERROR-05 Electrical or mechanical Press RESET.
DIFFERENT REGION DISC (RE-
GION ERR)
The disc does not have the same re-
gion number as this unit
Replace the DVD video with one bearing the
correct region number.
NON PLAYABLE DISC (NON-
PLAY)
This type of disc cannot be played
by this unit
Replace the disc with one this unit can play.
The disc is loaded upside down Check that the disc is loaded correctly.
THERMAL PROTECTION IN
MOTION (TEMP)
The temperature of this unit is out-
side of the normal operating range
Wait until the units temperature returns to
within normal operating limits.
Additional Information
En
90
Appendix