Filter
Top Products
Appendix E – DL Commands
50 DL™ User Manual Rev 3
GROUP
This command is used to maintain a set of log specifiers that would normally be used together in a specific scenario, e.g.
for base-station logging. Up to ten groups can be defined. The group name can be up to nine characters in length. If a
group named “POWERUP” is defined, this group’s log specification is executed when the DL determines what time it is,
after the DL is turned on. In that case, any other scheduled activity would be excluded.
There are four major syntactical forms, as shown below.
Syntax 1:
This command is used to display information about one or more existing groups.
GROUP
[option]
Command Option Description
GROUP - Command
option (none) Entered without arguments, this command displays the current groups as
a set of GRPA logs, followed by MSGA with Code=3001, Error=CMDFAIL,
SubCode=1001, SubCodeMsg=ENDGRPLIST.
group name If a valid group name (e.g. “alpha”) is given as an argument, only that log
group is displayed. The display is as described above.
Examples:
group
group alpha
NOTE: Use the PDC log, GROUPA/B, which contains extended group information that the GRPA/B log does not.
Syntax 2:
These commands are used to create and configure groups. Groups that are added are automatically saved to non-volatile
memory. If ten groups already exist, an error message is returned.