Filter
Top Products
2 – Set Up
24 DL™ User Manual Rev 3
Figure 6: Opening the Cover
Figure 7 illustrates the procedure to remove the PC Card. In the photo on the left, below, the cover has been unlocked
and opened, and the PC Card is visible. Note the arrow pointing to the eject button to the left of the card in this view.
You must push this button to partially eject the card; then grasp the card as illustrated in the photo on the right, below,
and pull it all the way out. To insert the card, ensure that it is correctly aligned before gently sliding it into the slot.
When the card slides all the way in and locks in place, the eject button will extend. If you attempt to insert the card
incorrectly, it will not go all the way in, and the eject button will not extend. In this case, do not force the card! Remove
it, orient it properly, and then insert it. After the card is locked in place, close the cover again.
Figure 7: Handling the PC Card