Filter
Top Products
G-PILOT 3100 Installation Manual
NAVMAN
5
Cleaning and maintenance
Clean the parts of the G-PILOT 3100 with a
damp cloth or mild detergent. Avoid abrasive
cleaners, petrol or other solvents.
Do not paint any part of the G-PILOT 3100
except for the cables.
1 Introduction
Using this manual
This manual describes how to install and set
up the G-PILOT 3100. Refer to the separate
G-PILOT 3100 Operation Manual for informa-
tion on how to use the G-PILOT 3100.
To install a G-PILOT 3100, you must perform
installation, dockside setup and sea trials (see
sections 3, 4 and 5).
To fully set up a G-PILOT 3100 after a part has
been changed or if a problem is suspected,
perform dockside setup and sea trials (see
sections 4 and 5).
To verify that the G-PILOT 3100 is operating
correctly, perform sea trials (see section 5).
Manual helm
GPS
NMEA
SPEED
3100
WIND
3100
More
display
units
Display
unit
Light duty
Heavy duty
12 V DC
Power supply
Gyro
Compass
Main
unit
NavBus
Clutch drive
(optional)
Parts supplied with G-PILOT
Other parts required
Optional parts
Rudder
feedback unit
Rudder
Power switch or switches
and power protection
Steering
drive
Rudder control
Key
1-1 A typical installation
Optional instruments
Note: Above shows typical
installation only. Please refer
to the information supplied with
your drive for further information.
NMEA