Filter
Top Products
G-PILOT 3100 Installation Manual
NAVMAN
25
4 Dockside setup
1 Turn the G-PILOT 3100 on (See G-PILOT
3100 Operation Manual). If the rudder
moves, immediately turn the power off (See
G-PILOT 3100 Operation Manual) and check
for incorrect wiring. Check that the display
unit shows AP3100 on the bottom line for a
couple of seconds, then the version number,
then displays the normal heading display.
If you try to enter AUTO and the rudder
feedback unit or compass have not yet
been calibrated, then the G-PILOT will
display CAL ERROR.
2 If the G-PILOT 3100 has been used before,
reset all user data to the factory defaults:
Perform the dockside setup:
after installing a G-PILOT 3100 system (see section 3)
after a part has been changed or if a problem is suspected
After dockside setup, perform the sea trials (see section 5 ).
4-1 Start dockside setup
WARNING
Until the rudder feedback unit is calibrated (see section 4-2), there is no rudder limit. The user
must ensure that rudder is not driven onto an endstop when using the jog command (see G-PILOT
3100 Operation Manual).
i Go to NVM RESET in the FACTORY
menu (See G-PILOT 3100 Operation
Manual).
ii Press > to turn the function on.
iii Press MENU to reset the data.
iv Hold AUTO to exit the menus.
3 Enter the user data listed in the User Data table
below (See G-PILOT 3100 Operation Manual
to fi nd what each data item means and how
to enter the data). Beside each item, write
the value of the user data that you enter.
4 After entering the data, hold AUTO to exit
the menus.
User Data table (to record installation setup data)
VESSEL menu
Item Data value
VSL TYPE . . . . . . . . . . . . . .
DRVE TYPE . . . . . . . . . . . . . .
WIND TYPE . . . . . . . . . . . . . .
HDG TYPE . . . . . . . . . . . . . .
MAG VAR . . . . . . . . . . . . . .
OPTIONS menu
Menu Data value
DODGE ANG . . . . . . . . . . . . . .
TACK ANG . . . . . . . . . . . . . .
GYBE ANGLE . . . . . . . . . . . . . .
TACK DELY . . . . . . . . . . . . . .
TURN RATE . . . . . . . . . . . . . .
ALARMS menu
Item Data value
CE ALARM . . . . . . . . . . . . . .
XTE ALARM . . . . . . . . . . . . . .
WPT AKN . . . . . . . . . . . . . .
WND ALARM . . . . . . . . . . . . . .
(SAIL only)
BAT ALARM . . . . . . . . . . . . . .
CUR ALARM . . . . . . . . . . . . . .
FACTORY menu
Item Data value
BKL GROUP . . . . . . . . . . . . . .
KEY BEEPS . . . . . . . . . . . . . .
NMEA2 DAT . . . . . . . . . . . . . .