Filter
Top Products
G-PILOT 3100 Installation Manual
NAVMAN
18
Installation
1 Find a suitable location and arrangement for the unit as described above.
2 Choose, assemble and fi t a suitable rudder linkage.
3 Fit the unit as shown below:
If necessary,
mount base on
block to set height.
Set rudder
amidships.
Rotate base so arrow on arm
points near centre line on
base. Fit two screws provided
loosely in middle of slots.
Rotate base so arrow on
arm points to centre line
on base. Fit third screw
provided, tighten all screws.
Join coupling to
rudder linkage.
Snap end into
correct hole in
arm.
Ensure rudder
is amidships.
If necessary, cut connecting
rod at this end, then replace
coupling and lock nut.
4 Wire the cable back to the main unit, following the wiring guide (see section 3-2-2).
Main unit
Plug connector into socket
Holes in the bulkheads
must be at least 18.5 mm
(0.73") diameter.