Filter
Top Products
G-PILOT 3100 Installation Manual
NAVMAN
12
3-4-2 Installing the steering drive
Install the steering drive according to one of the
diagrams on the following pages.
Note
Keep all wiring as short as possible.
Use the wire size given in the table below.
Follow the wiring guide (see section
3-2-2).
Wire less than #10 gauge will not fi t
directly into the four way terminal block.
Fit ferrules or reterminate the wire with
#10 gauge wire.
If more than one wire is to be fi tted to a
terminal of the four way terminal block,
join the wires together in a suitable way.
Wire size table
To choose a wire gauge for an installation:
1 Measure the length of twin cable required, i.e. the distance from the main control unit to the
heavy duty power supply or to the drive.
2 Choose the column with the cable length and the row with the circuit current. The intersection
of the row and column gives the preferred (minimum) cable wire gauge for less than 3% voltage
drop in a 12 V system.
Cable length (from main control unit to power supply or to drive)
0.7 m 1.5 m 2.2 m 3 m 3.7 m 4.5 m 5.2 m 6 m
Current 2.5 ft 5 ft 7.5 ft 10 ft 12.5 ft 15 ft 17.5 ft 20 ft
1 amp #18 #18 #18 #18 #18 #18 #18 #18
2 amp #18 #18 #18 #18 #18 #16 #16 #16
3 amp #18 #18 #18 #16 #16 #16 #14 #14
4 amp #18 #18 #16 #16 #14 #14 #14 #12
5 amp #18 #18 #16 #14 #14 #12 #12 #12
6 amp #18 #16 #16 #14 #12 #12 #12 #10
7 amp #18 #16 #14 #14 #12 #12 #10 #10
8 amp #18 #16 #14 #12 #12 #10 #10 #10
9 amp #18 #16 #14 #12 #12 #10 #10 #10
10 amp #18 #14 #12 #12 #10 #10 #10 #8
15 amp #16 #12 #12 #10 #10 #8 #8 #6
20 amp #14 #12 #10 #8 #8 #6 #6 #6