Navman G-PILOT 3100 GPS Receiver User Manual


 
G-PILOT 3100 Installation Manual
NAVMAN
16
3-5 Installing the rudder feedback unit
Physical
10 m (33 ft) cable
Arm
90 mm
(3.5")
220 mm
(8.7")
Base
Linkage
to rudder
Rudder
shaft
Arm rotates freely
around base.
LT8 connector
These two
distances to
be equal.
Connecting rod, with
quick release ttings
and lock nuts each end
End of connecting
rod snaps into one of
the holes on the arm.
Mounting requirements
These two
distances
to be equal.
Base to be adjacent
to rudder shaft so that
this angle is 90°
Rudder shaft to
be parallel to
shaft in base.
Rudder linkage
and arm to move
in the same
plane
Note
The unit is completely waterproof but should not be immersed.
Mount the unit on a panel which does not vibrate.
Follow the location guide (see section 3-2-1).
Adjust position of rod on
arm if required.
Cut connecting
rod if required.
Thread = M5