Filter
Top Products
G-PILOT 3100 Installation Manual
NAVMAN
22
Installation
1 Find a suitable location for the unit as described above.
2 Mount the unit with the three screws provided. Use a level to ensure the unit is vertical to
within 10°.
Less than
10° 10°
3 Wire the cable back to the main unit, following the wiring guide (see section 3-2-2).
Less than
10° 10°
Main unit
Plug connector into socket
Holes in the bulkheads
must be at least 18.5 mm
(0.73") diameter.
Note
If you move the gyro with respect to the compass while the power is on, wait for the heading
to stabilise.