TRACKER 5505/5505i/5605 Installation and Operation Manual
32
NAVMAN
Fuel display without engine RPM Fuel display with engine RPM
Range
The estimated boat range at the current fuel flow. The value can depend on the type of speed
sensor (see section 10-5).
Economy
The distance travelled per unit of fuel used. The value can depend on the type of speed sensor
(see section 10-5). The larger the value, the better the fuel economy. Adjust the throttle and trim to
achieve the best economy.
Fuel consumption curve
A graph of fuel consumption and boat speed as a function of engine RPM. Use the curve to monitor
and optimise boat performance (see section 10-6).
10-3 When you add or remove fuel
When you add or remove fuel, you must tell
the TRACKER, otherwise the fuel data will be
meaningless.
A When you completely fill a tank
Go to the fuel display and press .
Then:
On a single-tank boat, select Fill tank.
On a multi-tank boat, select Fill tank,
then select the tank you have filled.
Note: Underfloor fuel tanks are often difficult
to refill to the same level twice, due to air
pockets.
With underfloor fuel tanks:
Trim the boat to the same angle in the
water each time you follow procedure A.
Mostly use procedure B below when
adding fuel, but completely fill the tank
and follow procedure A about every tenth
time you add fuel.
B When you part fill a tank
1 Add fuel to a tank and write down how
much fuel you add.
2 From the Fuel display, press and
select Add fuel.
3 On a multi-tank boat, select the tank that
you have added fuel to.
4 Change the number to the amount of fuel
that you added.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de