Filter
Top Products
TRACKER 5505/5505i/5605 Installation and Operation Manual
23
NAVMAN
5-1 Waypoints display
To go to the waypoints display, press
, select Other, then select Waypoints.
The waypoints display is a list of the waypoints
that have been entered, each with waypoint
symbol, name, latitude and longitude, distance
and bearing from the boat, type and display
option.
If there are more waypoints than will fit on the
display, press or to scroll up or down a
page at a time.
5-2 Managing waypoints
5-2-1 Creating a new waypoint
Creating a new waypoint from any display
Press . A new waypoint is created at the
boat position with the default name and data.
To change the default data, see section 5-2-3.
Creating and editing a new waypoint from
the chart display
1 To create a waypoint at the boat position,
press ESC to switch the chart to centre on
boat mode (or press , see above).
Or, to create a waypoint at a different point,
move the cursor to that point on the chart.
2 Press .
3 A new waypoint, with the default name and
data is created.
4 Change the waypoint data if necessary (see
section 5-2-7). Select Save.
Creating a new waypoint from the
waypoints display
1 In the waypoints display, press and
select Create.
2 A new waypoint, with a default name and
data, is created at the boat position.
3 Change the waypoint data if necessary (see
section 5-2-7). Select Save.
Note: Waypoints can also be created when a
route is created (see section 6-2-1).
Moving a waypoint from the chart display
1 In the chart display, move the cursor to the
waypoint to move.
2 Press and select Move.
3 Move the cursor to the new position and
press .
Moving a waypoint from the waypoints
display
To move a waypoint from the waypoints
display, edit the waypoint (see section 5-2-3)
and change the latitude and longitude.
5-2-2 Moving a waypoint
CAUTION
!
!
CAUTION
DANGER
WARNING
Do not create a navigation waypoint on
land or in dangerous water.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de