Filter
Top Products
User’s manual NAVIGON 13xx | 23xx
Before you begin - 11 -
Inserting the navigation device into the cradle
1. Hang the navigation device by the upper recess on the upper lug of
the cradle. (See illustration)
2. Then press it towards the cradle so that it latches in place.
Supplying power to the navigation device
Included in delivery of the NAVIGON 13xx | 23xx is a car charger cable
with which power can be supplied to the navigation device via the
vehicle's cigarette lighter.
► Connect the car charger cable to the vehicle's cigarette lighter and
to the mini USB socket of the navigation device.
Note: Plug the USB connector into the navigation device as far it will
go! (Refer to "Troubleshooting" on page 63.)
Caution! Connect the car charger cable only to cigarette lighters with
an operating voltage of 10-24V.
Note: It takes approx. 2-3 hours to charge the device when the battery
is flat.
A fully charged battery enables up to 1 hours of use depending on the
device configuration.
Removing the navigation device from the cradle
On the bottom of the plate in which you hung the navigation device is a
clip.
1. Pull the clip towards yourself so that the device is released from the
clip.
2. Lift the device up and out of the cradle.