Filter
Top Products
User’s Manual NAVIGON 21xx max
- 48 - Navigation
Removing blocks and using original routes
Section blocks can be removed at any time.
► In the TURN-BY-TURN LIST window, tap on Options > Calculate
Original Route.
6.7.4 TMC (Traffic Information)
The integrated TMC receiver enables the navigation system to make
use of current traffic messaging. If necessary it can change your route
dynamically, for example in order to avoid a traffic jam.
Displaying traffic information
Current traffic information is available via the options button in many
windows.
1. Tap on Options
> Traffic.
The T
RAFFIC INFORMATION window opens.
Above the list the Traffic Information
button indicates the type of
traffic information listed and how many messages of this type there
are in the list.
2. Tap on Traffic Information
in order to select the messages you want
displayed.
For each traffic message in the list you are shown information about the
location of the traffic obstruction and its type.
► Tap on a message to display this information in detail.
The navigation system can Detour
( ) or Ignore ( ) congestion on
the route. The button shows the active status.
► Tap on the button to select the alternative setting.
► Tap on (Back) in order to close the TRAFFIC INFORMATION
window again.
TMC Settings
► In the TRAFFIC INFORMATION window, tap on Options > Traffic.
In the T
RAFFIC INFORMATION window you can set the TMC traffic station
and configure whether the reception of a traffic message concerning
your route should affect your route planning and if so how.
Tuning Mode
Tap on Tuning Mode
and select a method for selecting the TMC radio
station.