Filter
Top Products
User’s Manual NAVIGON 21xx max
- 12 - Before you begin
Inserting the navigation device into the cradle
1. Insert the navigation device into the lower lugs of the bracket. (See
illustration)
2. Then press the device towards the cradle until you hear the upper
clip latch in place.
Supplying power to the navigation device
Included in delivery of the NAVIGON 21xx max is a car charger cable
with which power can be supplied to the navigation device via the
vehicle's cigarette lighter.
► Connect the car charger cable to the vehicle's cigarette lighter and
to the mini USB socket of the navigation device.
Note: Without delay, plug the USB connector into the navigation device
as far it will go! (See "Troubleshooting" on page 63)
Caution! Connect the car charger cable only to cigarette lighters with
an operating voltage of 10-24V.
The LED on the bottom of the navigation device lights orange during
charging.
The LED goes out when the battery is fully charged.
Note: It takes approx. 4-5 hours to charge a flat battery.
A fully charged battery enables 3 hours of use.
Removing the navigation device from the cradle
1. Press the upper clip of the cradle towards the windscreen.
2. Tilt the navigation device slightly towards yourself.
3. Remove the device from of the cradle.