Filter
Top Products
11C-24
A
A
"
FUEL INJECTION PIPE REMOVAL
When loosening nuts at injection pipe ends, hold the nut
at other side (delivery holder nut for pump side, nozzle holder
nut at nozzle side) with wrench.
Caution
After disconnecting the injection pipe, plug the opening
so that no foreign particles get inside the pump or into
the injection nozzle.
A
B
"
CYLINDER HEAD BOLT REMOVAL
Loosen the bolts in 2 or 3 steps in order of the numbers
shown in the illustration, and remove the cylinder head
assembly.
INSTALLATION SERVICE POINTS
"
A
A
CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting
surface.
2. Check the number of identification holes on the cylinder
head gasket that was removed, and select a cylinder
head gasket with the same number of identification holes.
3. Place the cylinder head gasket on top of the cylinder
block so that the identification mark is facing upwards
as shown in the illustration.
"
B
A
CYLINDER HEAD BOLT INSTALLATION
1. When installing the cylinder head bolts, the length below
the head of the bolts should be within the limit.
If it is outside the limit, replace the bolts.
Limit (A): 119.7 mm
2. The head bolt washer should be installed with the burred
side caused by tapping out facing upwards.
3. Apply a small amount of engine oil to the thread section
and the washer of the cylinder head bolt.
Intake side
Front of engine
Exhaust side
351082
17964
Identification holes
Identification mark
Head bolt
Burred side
Headbolt
washer
(Engine
oil)
Cylinder
head
A