ENGINE <6A1> -
Engine Assembly
11B-33
INSTALLATION SERVICE POINTS
"
A
A
ENGINE ASSEMBLY INSTALLATION
Install the engine assembly, checking that the cables, hoses,
and harness connectors are not clamped.
"
B
A
ENGINE MOUNT STOPPER INSTALLATION
Clamp the engine mount stopper so that the arrow points
in the direction as shown in the diagram.
"
C
A
ENGINE MOUNT BRACKET INSTALLATION
1. Place a garage jack against the engine oil pan with a
piece of wood in between, and install the engine mount
bracket while adjusting the position of the engine.
2. Support the engine with the garage jack.
3. Remove the chain block and support the engine assembly
with the special tool.
"
D
A
HIGH-PRESSURE FUEL HOSE INSTALLATION
1. Apply a small amount of new engine oil to the O-ring.
Caution
Do not let any engine oil get into the delivery pipe.
2. While turning the high-pressure fuel hose to the right
and left, install it to the delivery pipe, while being careful
not to damage the O-ring. After installing, check that the
hose turns smoothly.
3. If the hose does not turn smoothly, the O-ring is probably
being clamped. Disconnect the high-pressure fuel hose
and check the O-ring for damage. After this, re-insert
the delivery pipe and check that the hose turns smoothly.
Engine side
Dynamic damper
Arrow
Engine
mount
stopper
Engine mount bracket