Mitsubishi Electronics QJ72LP25-25 Automobile Electronics User Manual


 
47
CHAPTER 4 SETTING AND PROCEDURE BEFORE OPERATION
4
4.4 Network Diagnostics (Online Test)
4.4.4 Communication test
4.4.4 Communication test
This test checks whether communications is normally performed between a test-executing station and a
communication-target station (specified with the network number and station number).
If the communication-target station is in another network, the relay network number and station number are displayed
and the routing parameter settings can be checked.
When the communication test is performed from a peripheral connected to the station number 1 in network number 1
to the station number 1 in network number 3 in the system above, the following window appears. The result shows that
communications between two stations is normal.
Host
station
Station
No.1
Station
No.1
Station
No.1
Station
No.2
Station
No.0
Station
No.2
Network No.1
(PLC to PLC
network)
Network No.2
(PLC to PLC
network)
Network No.3
(remote I/O
network)
Communication-target
station