Filter
Top Products
28
Basic
function
RAS function
Network
monitor
Host information
Checks the information of an entire network and the status
of the host station.
<Difference in comparison with the MELSECNET/10 remote
I/O station>
This function is performed using GX Developer on the
MELSECNET/H (MELSECNET/10 mode) remote I/O
station.
For details, refer to Page 75, Section 7.2.1.
Other station
information
Checks the status of communications, data link,
parameters, CPU modules, and loops of other stations
(including reserved stations).
<Difference in comparison with the MELSECNET/10 remote
I/O station>
The following points differ on the MELSECNET/H
(MELSECNET/10 mode) remote I/O station.
• When monitoring from a peripheral, GX Developer shall
be used.
• The parameter status of each station cannot be
monitored. Monitor them from the remote master station.
For details, refer to Page 77, Section 7.2.2.
Network monitor
details
Checks the status of the network line connected to a
peripheral, data link, CPU module, and parameters.
<Difference in comparison with the MELSECNET/10 remote
I/O station>
This function is performed using GX Developer on the
MELSECNET/H (MELSECNET/10 mode) remote I/O
station.
For details, refer to Page 78, Section 7.2.3.
Error history
monitor
Checks the history of forward/reverse loop errors,
communication errors, and transient transmission errors.
The details of the error history can be displayed and the
error history can be cleared.
<Difference in comparison with the MELSECNET/10 remote
I/O station>
This function is performed using GX Developer on the
MELSECNET/H (MELSECNET/10 mode) remote I/O
station.
For details, refer to Page 81, Section 7.2.4.
Data link status detection
function
Monitors the data link status using a peripheral.
<Difference in comparison with the MELSECNET/10 remote
I/O station>
This function is performed using GX Developer on the
MELSECNET/H (MELSECNET/10 mode) remote I/O
station.
For details, refer to Page 77, Section 7.2.2.
Function Description Availability