Mitsubishi Electronics QJ72LP25-25 Automobile Electronics User Manual


 
120
SD290
Device
assignment
(same as
parameter
contents)
Number of
points
assigned for X
Stores the number of points currently set for X devices.
S
(Initial)
New
Rem
SD291
Number of
points
assigned for Y
Stores the number of points currently set for Y devices.
SD292
Number of
points
assigned for M
Stores the number of points currently set for M devices.
SD294
Number of
points
assigned for B
Stores the number of points currently set for B devices.
SD296
Number of
points
assigned for
SB
Stores the number of points currently set for SB devices.
SD302
Number of
points
assigned for D
Stores the number of points currently set for D devices.
SD303
Number of
points
assigned for W
Stores the number of points currently set for W devices.
SD304
Number of
points
assigned for
SW
Stores the number of points currently set for SW devices.
SD315
Time reserved
for
communication
processing
Time reserved
for
communication
processing
• This register specifies the amount of processing time for
communication with GX Developer or other devices.
• The greater the value specified is, the shorter the response time for
communication with another device (such as GX Developer or serial
communication module) is. However, scan time will increase by the
specified time.
• Setting range: 1 to 100ms
• A setting outside the above range is regarded as no setting.
U
Q00J/
Q00/Q01
Qn(H)
QnPH
QnPRH
Rem
SD340
Ethernet
information
No. of modules
mounted
Indicates the number of mounted Ethernet module.
S
(Initial)
QCPU
Rem
SD341
I/O No.
(Information of
1st module)
Indicates I/O No. of mounted Ethernet module.
SD342
Network No.
(Information of
1st module)
Indicates network No. of mounted Ethernet module.
SD343
Group No.
(Information of
1st module)
Indicates group No. of the mounted Ethernet module.
SD344
Station No.
(Information of
1st module)
Indicates station No. of mounted Ethernet module.
No. Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
D9
Corres-
ponding
CPU