Filter
Top Products
G
Warning
When opening the roller sunblinds, make sure
that nobody can be injured during the opening
procedure.
The roller sunblinds are equipped with the
express operation and anti-entrapment
features. If the roller sunblinds block during
the opening procedure, the anti-entrapment
feature stops the roller sunblinds and opens
them again slightly.
The opening procedure of the roller sunblinds
can be stopped immediately by releasing the
roof switch or by operating the roof switch in
any direction if the roof switch has been
pressed beyond the point of resistance and
has been released.
Opening and closing
Overhead control panel
:
To open
;
To open
=
To close
X
Turn the key to position 2 in the ignition
lock.
X
Push or pull the 3 switch in the
corresponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by pressing again.
Resetting the panorama roof with
power tilt/sliding panel and the roller
sunblinds
Reset the panorama roof with power tilt/
sliding panel and the roller sunblinds if the
panorama roof with power tilt/sliding panel
or the roller sunblind do not open smoothly.
!
Do not open the panorama sliding sunroof
until it has been reset properly. Otherwise,
the panorama roof with power tilt/sliding
panel may lock in the open position.
If the panorama roof with power tilt/sliding
panel cannot be closed or adjusted,
contact a qualified specialist workshop,
e.g. a Mercedes-Benz Service Center.
X
Turn the key to position 2 in the ignition
lock.
X
Press the 3 switch to the point of
resistance in the direction of arrow ; and
hold it until the roller sunblinds are fully
open.
X
Press the 3 switch to the point of
resistance in the direction of arrow ; and
hold it until the panorama roof with power
tilt/sliding panel has opened about 10 cm.
X
Pull the 3 switch repeatedly to the point
of resistance in the direction of arrow =
until the panorama roof with power tilt/
sliding panel is fully closed.
X
Keep the 3 switch pulled for an
additional second.
X
Pull the 3 switch to the point of
resistance in the direction of arrow = and
hold it until the roller sunblinds are fully
closed.
X
Keep the 3 switch pulled for an
additional second.
X
Make sure that the panorama roof with
power tilt/sliding panel can be opened fully
again (Y page 86).
X
If this is not the case, the previously
described steps must be repeated or you
should consult a qualified specialist
workshop.
Sliding sunroof
87
Opening and closing
BA 204.9 USA, CA Edition A 2011; 1; 6, en-US
d2mwents Version: 3.0.3.6
2010-06-15T08:58:39+02:00 - Seite 87
Z