Filter
Top Products
Loosening/tightening the washer fluid
reservoir
You must remove the washer fluid reservoir
from the engine compartment before you can
replace the bulbs in the left-hand headlamp.
X
To detach: turn catch ; counter-
clockwise.
X
Swing washer fluid reservoir : far enough
to the side to allow the bulbs of the
headlamp to be replaced.
X
To attach: swing back washer fluid
reservoir :.
X
Turn catch ; clockwise.
Low-beam headlamp (halogen
headlamp)
X
Switch off the lights.
X
Open the hood.
X
Remove the headlamp cover (Y page 109).
X
Left-hand headlamp: detach the washer
fluid reservoir (Y page 110).
X
Turn housing cover : counter-clockwise
and pull it out.
X
Pull connector ; from bulb ?.
X
Detach retaining spring = downwards.
X
Pull out bulb ?.
X
Insert the new bulb.
X
Attach retaining spring =.
X
Attach connector ; to bulb ?.
X
Place housing cover : and turn it
clockwise until it engages.
X
Left-hand headlamp: fasten the washer
fluid reservoir (Y page 110).
X
Install the headlamp cover (Y page 109).
High-beam headlamps
X
Switch off the lights.
X
Open the hood.
X
Remove the headlamp cover (Y page 109).
X
Left-hand headlamp: detach the washer
fluid reservoir (Y page 110).
X
Turn housing cover : counter-clockwise
and pull it out.
X
Press the handle of bulb holder ; in the
direction of the arrow until bulb holder ;
is released.
X
Take out the handle with bulb holder ;.
X
Take the bulb out of bulb holder ;.
110
Changing bulbs
Lights and windshield wipers
BA 204.9 USA, CA Edition A 2011; 1; 6, en-US
d2mwents Version: 3.0.3.6
2010-06-15T08:58:39+02:00 - Seite 110