Filter
Top Products
the SmartKey is in the vehicle, the vehicle’s
electrical systems can be switched on or
the engine can be started using the
KEYLESS-GO start/stop button.
:
KEYLESS-GO start/stop button
;
Starter switch
X
Insert the KEYLESS-GO start/stop button
into the starter switch (if not inserted
already).
i
Allow for 2 seconds until the system has
detected the KEYLESS-GO start/stop
button.
X
Make sure the automatic transmission is in
park position P.
X
Do not depress the brake pedal.
KEYLESS-GO start/stop button
=
USA only
?
Canada only
Position 0
Before you press the KEYLESS-GO start/stop
button, the vehicle’s on-board electronics
have status 0 (as with SmartKey removed).
Position 1
X
Press the KEYLESS-GO start/stop button
once.
This supplies power for some electrical
consumers, e.g. wipers.
i
When you now open the driver’s door, the
power supply is switched off.
Ignition (or position 2)
X
Press the KEYLESS-GO start/stop button
twice.
This supplies power for all electrical
consumers.
When you switch on the ignition, all lamps
in the instrument cluster come on. The low-
beam headlamp indicator lamp, high-beam
headlamp indicator lamp, turn signal
indicator lamps, and the indicator lamps for
the fog lamps will only come on if activated.
If a lamp in the instrument cluster fails to
come on when the ignition is switched on,
have it checked and replaced if necessary.
If a lamp in the instrument cluster remains
on after starting the engine or comes on
while driving, refer to “Lamps in instrument
cluster” (Y page 260).
i
When you now press the KEYLESS-GO
start/stop button once and the driver’s
door is open, the power supply is switched
off.
Starter switch positions
79
Controls in detail
207_AKB; 2; 35, en-US
d2ureepe, Version: 2.11.8.1
2009-07-17T07:10:21+02:00 - Seite 79
Z