Filter
Top Products
function for as long as you hold the roof panel
switch.
Synchronizing
The tilt/sliding panel and roller sunblind must
be synchronized after a malfunction or if the
tilt/sliding panel does not open smoothly.
!
Do not attempt to open the tilt/sliding
panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Mercedes-Benz Center or call Roadside
Assistance.
X
Switch on the ignition.
X
Pull the roof panel switch repeatedly in
direction of arrow = to the resistance
point until the tilt/sliding panel is closed
completely.
X
Pull and hold the roof panel switch in
direction of arrow = for 1 more second.
X
Pull the roof panel switch repeatedly in
direction of arrow = to the resistance
point until the roller sunblind is closed
completely.
X
Pull and hold the roof panel switch in
direction of arrow = for 1 more second.
X
Check whether the tilt/sliding panel and
the roller sunblind can be opened
completely (Y page 165).
Loading and storing
Loading instructions
G
Warning!
Always fasten items being carried as securely
as possible. Use cargo tie-down rings and
fastening materials appropriate for the weight
and size of the load.
In an accident, during hard braking or sudden
maneuvers, loose items will be thrown around
inside the vehicle. This can cause injury to
vehicle occupants unless the items are
securely fastened in the vehicle.
To help avoid personal injury during a collision
or sudden maneuver, exercise care when
transporting cargo. Do not pile luggage or
cargo higher than the seat backrests.
The trunk is the preferred place to carry
objects.
Never drive a vehicle with the trunk open.
Deadly carbon monoxide (CO) gases may
enter vehicle interior resulting in
unconsciousness and death.
Load distribution
The total load weight including vehicle
occupants and luggage/cargo should not
exceed the total load limit indicated on the
corresponding Tire and Loading Information
placard located on the driver’s door B-pillar
(Y page 202).
The handling characteristics of a fully loaded
vehicle depend greatly on the load
distribution. It is therefore recommended to
load the vehicle according to the illustration
shown. The heaviest items are to be placed
towards the front of the vehicle.
Loading and storing
167
Controls in detail
207_AKB; 2; 35, en-US
d2ureepe, Version: 2.11.8.1
2009-07-17T07:10:21+02:00 - Seite 167
Z