Filter
Top Products
!
The vehicle may be towed only for
distances up to 30 miles (50 km) and at a
speed not to exceed 30 mph (50 km/h).
i
While being towed with the hazard
warning flasher in use, use the combination
switch in the usual manner to signal turns.
Only the selected turn signal will operate.
Upon canceling the turn signal, the hazard
warning flasher will operate again.
Fuses
Introduction
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and
systems secured by that fuse will stop
operating.
G
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system in
question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a fire,
and/or cause damage to electrical
components and/or systems. Have the cause
determined and remedied by an authorized
Mercedes-Benz Center.
A blown fuse must be replaced by an
appropriate spare fuse (recognizable by its
color or the fuse rating given on the fuse) of
the amperage recommended in the fuse
chart. Any Mercedes-Benz Center will be glad
to advise you on this subject.
i
In case of a blown fuse contact Roadside
Assistance or an authorized Mercedes-
Benz Center.
If a newly inserted fuse blows again, have the
cause determined and rectified by an
authorized Mercedes-Benz Center.
The fuse chart is located in the trunk with the
vehicle tool kit (Y page 230). The fuse chart
explains the fuse allocation and fuse
amperages.
Before replacing fuses
X
Engage the parking brake.
X
Make sure the automatic transmission is in
park position P.
X
Switch off all electrical consumers.
X
Turn off the engine.
X
Remove the SmartKey from the starter
switch.
X
Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position 0, same as with the SmartKey
removed from the starter switch). The
driver’s door then can be closed again.
Fuse box in passenger compartment
!
Do not use sharp objects such as a
screwdriver to open the fuse box cover in
the dashboard. You could damage the fuse
box cover or the dashboard.
X
Open the driver’s door.
X
Opening: Using your hands, pull fuse box
cover : in direction of arrow = and
remove in direction of arrow ;.
X
Closing: Hook fuse box cover : into the
opening at the front.
X
Press fuse box cover : back on until it
engages.
290
Fuses
Practical hints
207_AKB; 2; 35, en-US
d2ureepe, Version: 2.11.8.1
2009-07-17T07:10:21+02:00 - Seite 290