Filter
Top Products
Useful features
196
Operation of integrated remote control
X
Switch on the ignition.
X
Select and press the appropriate inte-
grated signal transmitter button (2, 3 or
4) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
Erasing the integrated remote control
memory
X
Switch on the ignition.
X
Simultaneously press and hold outer signal
transmitter buttons 2 and 4, for approx-
imately 20 seconds, until indicator lamp
1 flashes rapidly. Do not hold for longer
than 30 seconds.
The codes of all three channels are erased.
i
If you sell your vehicle, erase the codes of
all three channels.
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
R
Check the frequency of hand-held remote
control 5 (typically located on the reverse
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
R
Put a new battery in hand-held remote con-
trol 5. This will increase the likelihood of
the hand-held remote control sending a
faster and more accurate signal to the inte-
grated remote control.
R
While performing step 3, hold hand-held
remote control 5 at different lengths and
angles from the signal transmitter button
(2, 3 or 4) you are programming.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
R
If another hand-held remote control is avail-
able for the same device, try the program-
ming steps again using that other hand-
held remote control. Make sure new
batteries are in the hand-held remote con-
trol before beginning the procedure.
R
Straighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
i
Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the inte-
grated remote control, contact an author-
ized Mercedes-Benz Center, or call Mer-
cedes-Benz Customer Assistance Center
(in the USA) at 1-800-FOR-MERCedes, or
Customer Service (in Canada) at
1-800-387-0100.
i
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Controls in detail