Filter
Top Products
Power windows
108
X
Express operation: Press or pull switch
1 or 2 past the resistance point and
release.
The corresponding door window opens or
closes completely.
X
Stopping during Express operation:
Press or pull the respective switch again.
Closing when a door window is blocked
G
Warning!
Make sure that nobody can become trap-
ped and be seriously or even fatally injured
when closing a door window with greater
force or without automatic reversal func-
tion.
If the upward movement of a door window is
blocked during the closing procedure, the
door window will stop and open slightly. How-
ever, the door window will exert greater force
before reversing than when the door window
is closed in express operation. Please exer-
cise caution!
X
Immediately after the door window has
stopped because it was blocked, pull the
respective switch upwards until the door
window is fully closed.
If the door window is blocked again and opens
slightly:
X
Immediately after the door window was
blocked, pull the respective switch
upwards until the door window is fully
closed.
G
Warning!
Pressing and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door win-
dow to close without any reversal function
for as long as you hold the switch.
Opening and closing the rear side win-
dows
X
Opening: Open the door window.
X
Press switch 1 or 2 again.
The corresponding rear side window will
open completely.
X
Closing: Close the door window.
X
Pull and hold switch 1 or 2.
The corresponding rear side window will
move upwards until you release the switch.
Closing with KEYLESS-GO
When locking the vehicle, you can simultane-
ously close the windows.
X
Press and hold the lock button on an out-
side door handle (Y page 79) until the win-
dows are completely closed.
X
Release the lock button on the outside door
handle to interrupt the closing procedure.
Synchronizing power windows
The windows must be synchronized after the
battery has been disconnected or if the win-
dows cannot be fully closed (Express opera-
tion).
Each power window must be synchronized
separately.
X
Close all doors.
X
Switch on the ignition.
X
Pull and hold switch 1 or 2
(Y page 107) until the respective window is
closed.
The window opens again slightly.
Controls in detail