Filter
Top Products
Other display messages
If the ignition is not switched on, the following
message appears in the multifunction
display:
Switch
ignition on to
check engine
oil level.
X
Switch on the ignition.
If you see the message:
Observe
Waiting Time
X
If the engine is at operating temperature,
wait 5 minutes before repeating check
procedure.
X
If the engine is not at operating
temperature yet, you must wait 30 minutes
before checking oil.
If you see the message:
Engine Oil
Level
Not With
Engine On
X
Turn off the engine.
X
If the engine is at operating temperature,
wait 5 minutes before checking oil.
X
If the engine is not at operating
temperature yet, you must wait 30 minutes
before checking oil.
If there is excess engine oil with the engine at
normal operating temperature, the following
message appears in the multifunction
display:
Engine Oil
Reduce Oil
Level
X
Have excess oil siphoned or drained off.
Contact an authorized Mercedes-Benz
Center.
!
Excess oil must be siphoned or drained
off. It could cause damage to the engine
and emission control system not covered
by the Mercedes-Benz Limited Warranty.
For information on messages in the
multifunction display concerning engine oil,
see the “Practical hints” section
(Y page 207).
Adding engine oil
!
Only use approved engine oils and oil
filters required for vehicles with
Maintenance System. For a listing of
approved engine oils and oil filters, contact
an authorized Mercedes-Benz Center or
visit www.mbusa.com (USA only).
Using engine oils and oil filters of
specification other than those expressly
required for the Maintenance System, or
changing of oil and oil filter at change
intervals longer than those called for by the
Maintenance System will result in engine or
emission control system damage not
covered by the Mercedes-Benz Limited
Warranty.
G 550
G 55 AMG
Engine compartment
151
Operation
463_AKB; 2; 52, en-US
d2ureepe, Version: 2.11.7.1
2008-12-02T10:52:11+01:00 - Seite 151
Z