Filter
Top Products
359
Operation
Engine compartment
̈ Wipe oil dipstick 1 clean.
̈ Fully insert oil dipstick 1 into the
dipstick guide tube.
̈ Pull out oil dipstick 1 again after
approximately 3 seconds to obtain
accurate reading.
The oil level is correct when it is between
lower mark 3 (min.) and upper mark 2
(max.) of the oil dipstick.
̈ If necessary, add engine oil.
For more information on engine oil, see
“Technical data” section (
୴ page 536) and
(
୴ page 538).
For information on messages in the multi-
function display concerning engine oil, see
the “Practical hints” section (
୴ page 451).
Adding engine oil
Example illustration R 350 4MATIC
1 Filler cap
̈ Unscrew filler cap 1 from filler neck.
̈ Add engine oil as required. Be careful
not to overfill with oil.
i
The filling quantity between the upper and
lower marks on the oil dipstick is approximately
2.1 US qt (2.0 l).
!
Only use approved engine oils and oil filters
required for vehicles with Maintenance System.
For a listing of approved engine oils and oil
filters, refer to the Factory Approved Service
Products pamphlet (USA only) in your vehicle
literature portfolio, or contact an authorized
Mercedes-Benz Light Truck Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System, or changing of oil and oil
filter at change intervals longer than those called
for by the Maintenance System will result in
engine or emission control system damage
not covered by the Mercedes-Benz Limited
Warranty.
୴୴