Filter
Top Products
137
Controls in detail
Seats
Removing head restraints
Seat position for removal of head restraints
from outboard second-row seats
1 Head restraint
2 Release button
̈ To remove head restraint 1, pull head
restraint 1 to its uppermost position.
̈ Press release button 2 and pull out
head restraint 1.
Installing head restraints
̈ Insert head restraint 1 into openings
on the seat backrest.
̈ Push head restraint 1 down until it
audibly engages.
̈ Push release button 2 and adjust
head restraint 1 to the desired
position (
୴ page 135).
Armrests
6-seat vehicles
The second-row seat armrests can be
folded up, when loading for example, and
adjusted.
Folding up:
̈ Move the armrest into a vertical
position until it engages.
Adjusting:
̈ With the armrest folded up, disengage
the armrest by pushing it towards the
rear slightly.
̈ Fold the armrest down to the lowest
and then to the desired position until it
engages.
̈ To readjust the armrest to a higher
position, move armrest up to the
desired position until it engages.
i
The head restraint of the second-row middle
seat* and the third-row seat head restraints are
removed in the same manner.
i
On the outboard second-row seats, the
guide bar with the detent must be on the left.
i
The head restraint of the second-row middle
seat* and the third-row seat head restraints are
installed in the same manner.
i
To readjust the armrest to a lower position,
you must first fold up the armrest again and re-
peat the steps above.