Filter
Top Products
255
Controls in detail
Panorama roof with power tilt/sliding panel*
Fully opening (Express-open) the
panorama roof with tilt/sliding panel
̈ Pull the roof panel switch past the
resistance point in direction of
arrow 1 (
୴ page 254) and release.
The tilt/sliding panel opens com-
pletely.
Stopping the panorama roof with
tilt/sliding panel during Express-open
̈ Move the roof panel switch in any
direction.
The tilt/sliding panel will stop in its
current position.
Synchronizing the panorama roof with
power tilt/sliding panel
The tilt/sliding panel and its roller
sunblinds must be synchronized
ț after the battery has been
disconnected or discharged
ț after a malfunction
ț if the tilt/sliding panel does not open
smoothly
̈ Switch off the ignition (୴ page 40) and
remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
̈ Switch off the ignition (୴ page 41).
̈ Open the driver’s door (this puts
the starter switch in position 0,
same as with the SmartKey
removed from the starter switch).
The driver’s door then can be
closed again.
̈ Remove the fuse for the tilt/sliding
panel from the fuse box (
୴ page 518).
!
Do not attempt to open or close the
tilt/sliding panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding panel
could otherwise lock-up in the open position.
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Mercedes-Benz Light Truck Center or call
Roadside Assistance (
୴ page 325).
i
For information on which fuse box contains
the fuse for the power tilt/sliding panel, see the
fuse chart provided with the vehicle tool kit
(
୴ page 469). ୴୴