Filter
Top Products
112
Controls in detail
Lighting
Switching on high beams
Combination switch
1 High beam
2 High beam flasher
̈ High beam: Turn the exterior lamp
switch to position B (
୴ page 108).
̈ Push the combination switch in the di-
rection of arrow 1.
The high beam indicator A in the in-
strument cluster comes on
(
୴ page 26).
̈ High beam flasher: Pull the combina-
tion switch briefly in the direction of
arrow 2.
Headlamp cleaning system*
The headlamps are automatically cleaned
with a high-pressure water jet when, at the
same time,
ț the engine is running
ț the headlamps are switched on
ț the windshield wipers have wiped the
windshield with washer fluid for the
first time.
The headlamps are cleaned every tenth
time the windshield is washed with washer
fluid.
When you switch off the headlamps or the
ignition, the automatic function is reset
and will start counting the next time from
the beginning.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
୴ page 330).
Corner-illuminating front fog lamps*
(With Bi-Xenon* headlamps only)
The corner-illuminating front fog lamps
improve illumination of the area in the
direction into which you are turning.
The corner-illuminating front fog lamps will
operate with the engine running and with:
ț the exterior lamp switch in
position B or * (
୴ page 108)
or
ț the daytime running lamp mode acti-
vated (
୴ page 110).
i
The corner-illuminating front fog lamps will
only come on in low ambient lighting conditions.
i
If you are driving faster than 25 mph
(40 km/h) or have the front fog lamps switched
on, the corner-illuminating front fog lamps
function is not available.