Filter
Top Products
361
Controls in detail
Driving and parking
̈ If you are starting the engine with
KEYLESS-GO: Close any doors that
may be open to allow for better detec-
tion of the SmartKey with
KEYLESS-GO.
or
̈ Remove the KEYLESS-GO* start/stop
button from starter switch.
̈ Start the engine with the SmartKey as
radio signals from another source may
be interfering with the SmartKey with
KEYLESS-GO.
̈ Repeat the starting procedure
(
୴ page 359). Remember that extend-
ed starting attempts can drain the bat-
tery.
̈ Get a jump start (୴ page 639).
If the engine does not start after several
starting attempts, there could be a mal-
function in the engine electronics or in the
fuel supply system.
̈ Call Roadside Assistance.
̈ Notify an authorized Mercedes-Benz
Center.
Driving off
̈ Depress the brake pedal.
The gear selector lever can now be
used.
̈ Shift automatic transmission to D or R.
̈ Release the brake pedal.
̈ Carefully depress the accelerator
pedal.
The electric parking brake is automati-
cally released (
୴ page 364).
The red brake warning 0 (USA only)
or ! (Canada only) in the instru-
ment cluster goes out.
Once the vehicle is in motion, the auto-
matic central locking system engages
and the locking knobs in the doors
move down.
After a cold start, the automatic transmis-
sion shifts at a higher engine revolution.
This allows the catalytic converter to reach
its operating temperature earlier.
i
Wait for the gear selection process to com-
plete before setting the vehicle in motion.
i
Shifting from gear position P to position R,
N, or D is only possible with the brake pedal de-
pressed. Without the brake pedal depressed, the
gear selector lever can be moved, but the park-
ing pawl remains engaged, not allowing shifting
to occur.
i
After driving off the doors and the trunk lock
automatically.
You can open a locked door from the inside.
Open door only when conditions are safe to do
so.
You can deactivate the automatic locking using
the COMAND system (
୴ page 223).
୴୴