Filter
Top Products
265
Control systems
Voice Control* telephone
“Correction”
Using the command “Correct” will correct
the last entered digit block. After speaking
the command, the last digit block is delet-
ed and all previously entered digits are re-
peated. The system then prompts you to
continue your input.
Sample dialog:
s Dial number
t Please say the number
s One two three
t One two three
s Four five six seven
t Five five six seven
s Correction
t One two three, please continue
s Four five six seven
t Four five six seven
s OK
t Dialing
“Delete”
Using the command “Delete” will erase all
digits entered. The system then prompts
you to start your input again.
Sample dialog:
s Dial number
t Please say the number
s One two three
t One two three
s Four five six seven
t Four five six seven
s Delete
t Number deleted. Please enter the
number again
s Four two seven three
t Four two seven three
s Three nine one
t Three nine one
s OK
t Dialing
“Redial”
Use the command “Redial” to dial the last
dialed number.
“Save name” (COMAND address book)
Use the command “Save name” to create a
new entry in your COMAND address book.
After using the command, the system will
prompt you to enter a phone number.
Digits from “Zero” to “Nine” can be en-
tered (
୴ page 264).
Speak the telephone number
ț as a continuous string
or, with longer phone numbers,
ț in form of digit blocks (three to five dig-
its). After each digit block (separate the
digit blocks by using an approximately
0.5 second pause), the Voice Control
System repeats the recognized digits
and waits until you continue speaking.