Filter
Top Products
119
Control systems
COMAND telephone*
Entering the PIN
Entering using the COMAND controller
̈ Select “Telephone” Ǟ “Telephone” Ǟ
“Telephone”.
̈ Entering: Select all the digits in se-
quence.
̈ Deleting a digit: Select ) and briefly
press n.
̈ Deleting an entire number: Select )
and press and hold n until the number
is deleted.
̈ Confirming an entry: Press n.
Entering using the telephone keypad
̈ Entering: Enter digits (୴ page 117).
̈ Confirming an entry: Press n or
press s.
Entering the PIN2
The phone may request the PIN2 in order
to use certain functions. A corresponding
message appears in the display.
̈ Enter PIN2 digits into mobile phone.
Entering the PUK/PUK2
If you enter the PIN or PIN2 incorrectly
three times, the SIM card will be locked.
A corresponding message appears in the
display. It is necessary to enter the
PUK/PUK2 to unlock it. The PUK and/or
PUK2 are provided by your telephone ser-
vice provider.
̈ Enter PUK/PUK2 digits into mobile
phone.
Entering the unlock code
Many mobile phones can be protected
from unauthorized use with an unlock code
(see mobile phone operating instructions).
If you wish to use the phone functions
when the unlock code is active, a screen
appears requesting that you enter the un-
lock code. You cannot use the phone func-
tions (except “911” emergency call) until
you have entered the unlock code.
̈ Proceed in the same way as entering
the PIN (
୴ page 119).
i
The PIN entry applies only to GSM mobile
phones.
i
The PIN2 entry applies only to GSM mobile
phones.
i
The PUK/PUK2 entry applies only to GSM
mobile phones.