Filter
Top Products
336
Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach, and comfort. The head re-
straint should also be adjusted for proper
height. See also the section on air bags
(
୴ page 45) for proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the inside and outside
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety Stan-
dards 213 and 225 and Canadian Motor
Vehicle Safety Standards 213 and 210.2.
With the memory function you can store up
to 3 different settings.
The following settings are saved for each
stored position the driver’s door:
ț Seat position and lumbar support
ț Multicontour seat*: previously select-
ed setting
ț Drive-dynamic multicontour seat*: ac-
tivation/deactivation
ț Steering wheel position
ț Exterior rear view mirrors position
The following settings are stored when us-
ing the buttons on the front passenger
door:
ț Seat position and lumbar support
ț Multicontour seat*: previously select-
ed setting
ț Drive-dynamic multicontour seat*: ac-
tivation/deactivation
The following settings are stored when us-
ing the buttons* on the rear passenger
doors (Canada only):
ț Seat position
ț Multicontour seat*: previously select-
ed setting
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.