Filter
Top Products
150
Control systems
COMAND navigation (introduction)
Adjusting the map scale
̈ Rotate ymz.
Rotating clockwise zooms in, rotating
counterclockwise zooms out.
Saving crosshair position as destination
in last destinations list
̈ Showing menu system, if neces-
sary: Press n.
̈ Saving: Select “Position” Ǟ “Save Po-
sition”.
COMAND saves the crosshair position
as a destination in the last destinations
list (
୴ page 201).
Hiding the crosshair
̈ Press back button L in the center
console (
୴ page 80).
The crosshair disappears and the map
is centered on the vehicle position.
or
̈ Set the map to the vehicle or destina-
tion position, see the explanation be-
low.
Centering the map on the vehicle or
destination position
̈ Centering on the vehicle’s position:
Select “Navi” Ǟ “Position” Ǟ “Vehicle
Position Map”.
or
̈ Press L when the crosshair is dis-
played.
̈ Centering on the destination:
Select “Navi” Ǟ “Position” Ǟ “Destina-
tion Position Map”.
Basic settings
Map orientation
1 Current map orientation
The following may be displayed:
ț 8 = “Heading Up” (the map is dis-
played so that the direction of travel is
always up; the orange point of the icon
points north)
ț 9 = “North Up” (the map view is dis-
played so that north is always up)
i
If you have moved the map, you can use this
function to rapidly return the map to the position
of the vehicle or destination. It is only possible to
center the map on the destination position when
route guidance is active.
i
You can make the following settings regard-
less of whether route guidance is active or inac-
tive.