Filter
Top Products
251
Controls in detail
Power windows
Fully closing the door windows
(Express-close)
̈ Pull switch 1 or 2 past the
resistance point and release.
The corresponding window closes
completely.
Stopping windows during
Express-operation
̈ Press or pull the respective power win-
dow switch again.
Synchronizing power windows
The power windows must be resynchro-
nized each time
ț after the battery has been
disconnected.
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close).
̈ Switch on the ignition (୴ page 38).
̈ Pull the power window switches until
the side windows are closed.
̈ Hold the switches for approximately
one second.
The power windows are synchronized.
!
If the upward movement of a door window is
blocked during the closing procedure, the door
window will stop and open slightly.
Remove the obstruction, pull the switch again
past the resistance point and release.
If the door window still does not close when
there is no obstruction, then pull the switch and
hold it. The door window will then close without
the obstruction sensor function.
Warning! G
Driver's door only:
If within five seconds you again pull the
switch past the resistance point and re-
lease, the automatic reversal will not func-
tion.