Filter
Top Products
161
Controls in detail
Control system
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
୴ page 126).
Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the vehi-
cle is unlocked using button Πon the
SmartKey or SmartKey with
KEYLESS-GO*:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
ț Front fog lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey, the lamps
will switch off automatically after
approximately 40 seconds.
̈ Move the selection marker with
button æ or ç to the
Lighting
submenu.
̈ Press button j or k repeatedly
until the message
Surround lighting
function
appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press button æ or ç to switch
the locator lighting function
On
or
Off
̈ Turn the exterior lamp switch to
position U when exiting the vehicle.
The locator lighting feature is
activated.
i
For safety reasons, resetting the
Lighting
submenu to factory settings (
୴ page 154) while
driving will not deactivate the daytime running
lamp mode.
The following message appears in the
multifunction display:
Lighting - Cannot be completely reset
to factory settings while driving.