Filter
Top Products
53
Getting started
Parking and locking
Turning off engine with KEYLESS-GO*
̈ Place the gear selector lever in P.
̈ Press and hold the KEYLESS-GO
start/stop button until the engine
shuts off.
With the driver's door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
୴ page 31).
̈ Press the seat belt release button
(
୴ page 41).
1 Lock button on the door handle
̈ After exiting the vehicle, press lock
button 1 on the door handle or on the
trunk lid.
The locking knobs on the doors move
down. The turn signal indicators light
up briefly.
For more information, see “Controls in de-
tail” (
୴ page 85).
!
If you hear a warning signal you have ei-
ther:
ț forgotten to turn off the lights, or
ț not put the gear selector lever in P
before opening the driver’s door
Turn off the lights or place the gear se-
lector lever in P.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure that there
is no possibility of someone getting caught
in a door during closing.
Warning! G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take the
KEYLESS-GO* card (if so equipped) with
you, and lock your vehicle. Do not leave chil-
dren unattended in the vehicle, or with ac-
cess to an unlocked vehicle. Unsupervised
use of vehicle equipment may cause an ac-
cident and/or serious personal injury.