Filter
Top Products
140
Controls in detail
Control system
Which messages will appear in the display
field depends on whether your telephone is
switched on or off:
ț If the telephone is off, the message in
the multifunction display is:
TEL OFF
.
ț If the telephone is on:
The telephone will then search for a
network. During this time the display
reads
NO SERVICE
.
As soon as the telephone has found a
network,
READY
is indicated in the dis-
play.
The standby message indicates that your
telephone is ready for use and you can op-
erate it using the control system.
Answering a call
When your telephone is ready to receive
calls, you can answer a call at any time. In
the display you will then see the message:
̈ Press button í.
You have answered the call. In the dis-
play you see the duration of the call po-
sitioned above the number.
Ending a call
̈ Press button ì.
You have ended the call. In the display
you will again see the standby mes-
sage.
Dialing a number from the phone book
If your telephone is ready to receive calls,
you may select and dial a number from the
phone book at any time.
̈ Press button ÿ or è repeatedly
until you see the
TEL
menu in the dis-
play.
̈ Press button j or k.
The control system reads the phone
book which is stored in the telephone.
This may take up to 30 seconds. In the
display you will see the message
PLEASE WAIT!
.
When the message
PLEASE WAIT!
dis-
appears, the phone book has been
loaded.
i
If you do not wish to accept a call,
press button
ì.