Filter
Top Products
341
Practical hints
Flat tire
1 Jack support tube hole
2 Jack arm
3 Crank
̈ Insert jack arm 2 fully into tube hole 1
up to the stop.
̈ Keeping jack in this position, turn
crank 3 clockwise until the jack base
meets the ground. Make sure the jack
is vertical (plumb line).
̈ Continue to turn the crank until the tire
is a maximum of 1.2 in (3 cm) from the
ground.
Removing the wheel
1 Alignment bolt
̈ Unscrew upper-most wheel bolt and re-
move.
̈ Replace this wheel bolt with alignment
bolt 1 supplied in the tool kit.
̈ Remove the remaining bolts.
̈ Remove the wheel.
Warning! G
Insert the jack arm fully into the jack sup-
port tube hole up to the stop. Otherwise the
vehicle may fall from the jack and cause per-
sonal injury or damage to the vehicle.
Warning! G
The jack is intended only for lifting the vehi-
cle briefly for wheel changes. It is not suited
for performing maintenance work under the
vehicle.
ț Never start the engine when the vehicle
is raised.
ț Never lie down under the raised vehicle.
!
Do not place wheel bolts in sand or dirt.
This could result in damage to the bolt
and wheel hub threads.