Filter
Top Products
117
Controls in detail
Memory function
Memory function
The memory button and stored position
switch are located on the door.
You can store up to three different settings
per SmartKey or KEYLESS-GO* card.
The following settings are saved for each
stored position:
ț Seat and backrest position
ț Settings for the multi-contour seat*
ț Steering wheel position
ț Inside rear view mirror position
ț Exterior rear view mirror position
ț Automatic climate control
These key dependent memory settings can
be deactivated if desired (
୴ page 156).
1 Stored position buttons
2 Memory button
̈ Make sure that the ignition is switched
on or the relevant door is open and the
SmartKey is inserted in the starter
switch.
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach, and com-
fort. The head restraint should also be
adjusted for proper height. Also see
“Airbags” (
୴ page 57) section for prop-
er seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the inside and
outside rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213
and 210.2.
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.